Back to Album

Next photo

Previous photo



Whitepointer's fibreglass work is good quality but the mould they they make their nosecone from is a long way from perfect.  Both sides are shaped differently and no matter how hard I tried I couldn't get it to sit square on the chassis so I had to slice the passenger side open and spread it by about 20mm to get an acceptable fit.  This was not caused by my joining it down the middle and it's disapointing to pay so much for a product and then spend so much time rectifying manufacturing problems.

[Locost  Home] [Locost Finished] [Magazine Article] [Background] [Donor Car] [Specifications] [Chassis build] [Photo album] [Donor car] [MX5 parts] [Assembling] [Chassis build] [Front end] [Rear end] [Engine] [Electrics] [Bits & pieces] [Bodywork] [Body finishing] [Interior] [Rotisserie] [Bright 2006] [Clubman cars] [Locost links] [Meet the owner]