Back to Album

Next photo

Previous photo



The top edges also required annealing to make it easier to fold them over the top tube.  The bottom edge was trimmed off level with the lower tube rather than roll it under the lower tube as it was a much easier and neater finish.

[Locost  Home] [Locost Finished] [Magazine Article] [Background] [Donor Car] [Specifications] [Chassis build] [Photo album] [Donor car] [MX5 parts] [Assembling] [Chassis build] [Front end] [Rear end] [Engine] [Electrics] [Bits & pieces] [Bodywork] [Body finishing] [Interior] [Rotisserie] [Bright 2006] [Clubman cars] [Locost links] [Meet the owner]